Your water heater is one that is used and much more costly appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating and costs.
Regular flushing of your water heater are probably the single most important step you consider to prolong its service life this particular save energy. Over a period of time, sediments enhance in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most areas of the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double living of your water heater from 3-5 to 7-10 years. Are investigating costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is a must in today’s affordable. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month or so.
To drain your water heater, first you should set the thermostat to pilot (if it is really a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on the water inlet line going into your water heater. Then you’re connect a garden hose to the drain valve located in the bottoom of the space heater. Open the drain and allow it to run until all of the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until drinking water flows out smoothly. This will allow air to vent because of the heater and the water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so may be less corrosive to your plumbing system, particularly in areas possess hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and merchandise to be fitting.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX